Supervisor:
Southwest Ordnance Industry Bureau
Organizer:
Chongqing Ordnance Industry Society
Chongqing University of Technology
Chongqing University of Technology
Vol. 45 No. 2 (2024) Published: 2024-02-28
- Research on the influence of muzzle vibration characteristics on firing accuracy of automatic gun
- Visual design and implementation of damage assessment for phased array radar by explosive warhead based on Unity3D
- Study on damage and hot spot generation of explosive charge during penetration
- Research on aircraft structural health monitoring strategy
- Design method for electromagnetic noise reduction of AC traction motors based on optimization of stator slot structure
- Low temperature heating design and its optimization of low cost aeroengine controller
- Experimental study on velocity attenuation law of fragment simulated projectile
- Research on damage effectiveness of prefabricated fragments on human targets in two postures
- Multi parameter structural optimization of cylindrical cone liner based on orthogonal design
- Fuzzy fault tree based safety assessment of radio fuzes for anti aircraft guns
- Overall performance study of variable geometry turbine gas turbine
- Analysis of the influence of ballistic insert plate on its bulletproof performance under high temperature environment
- Analysis for stable tracking torque of self propelled antiaircraft gun under high dynamic conditions
- Liquid cooling analysis of series parallel hybrid flow channel of permanent magnet synchronous motor casing
- Influence of fin parameters on the convection radiation coupled heat transfer characteristics in enclosed cavity with internal heat source based on response surface analysis
- Design and research of ejector based on skid mounted nozzle back pressure control
- AL GAN: A lightweight GAN underwater image enhancement incorporating attention mechanisms
- Equivalent mechanics modeling of typical negative Poisson’s ratio structure under different load boundaries
- Mesoscopic damage model and constitutive model of explosive transmission under impact load
- Analysis of the effect of altitude on the pressure distribution pattern of chemical explosion shock wave
- Numerical simulation of propagation law of explosion shock wave in variable cross section channel
- Investigation of the effect of complex motion during clap fling on the lift performance of bristled wings
- An algorithm of calculating mortar exterior ballistic model based on prediction correction method
- Research on fragmentation behavior of ceramic panel and backplane driven by detonation
- Numerical simulation of aircraft wake vortex under different B V frequencies
- A semiparametric estimation method for aircraft trajectory
- Aircraft maneuver recognition based on autoencoder support vector machine
- Multi feature short term load forecasting based on VMD Stacking ensemble learning
- Design of whole process test system for electronic time fuze circuit components
- Target attribute recognition method based on image and track information fusion
- Numerical simulation of explosive welding of aluminum/stainless steel bimetallic tubes
- Propagation analysis of rail three dimensional surface crack based on ABAQUS/FRANC3D
- Research on mechanical fault diagnosis method based on synchro extractinggeneralized S transform
- Stiffness reliability sensitivity analysis of aircraft double angle tensile joint
- Research on small target detection technology based on slicing aided inference
- Remote sensing image detection method based on global context attention
- Research on spectral reflectance reconstruction method based on camera RGB value
- Study on buffer performance of TPU material with negative Poisson’s ratio structure
- Crystal structure and thermal stability of 4 Amino 3, 7 bis(1H tetrazol 5 yl) ［1, 2, 4］triazolo［5, 1 c］［1, 2, 4］triazine (DTTA)
- In plane elastic parameters of embedded co cured stitched damping composites